Electronic Oven Control; Displays; Start; Cancel Off - KitchenAid KERC507 Use & Care Manual

ELECTRONIC OVEN CONTROL
1 2
g 10 11
1. Oven Cavity Symbol
2. Heat Setting
3. Oven Display
4. Start/Stop Time
5. Number Pads
6. Control Lock
7. Time of Day/Timer Display
8. Start
g. Oven Settings
10. EASYCONVECT
TM
CONVERSION
11. Timed Cooking
12. Convect Full Meal
13. Oven Light
14. Clock
15. Timer
16. Surface Light
17. Cancel Off
When pressing any control pad function on the Electronic Oven
Control, use the pad of your finger to press the desired function.
Hold down the pad a few seconds, or until the desired function
enters on the display.
When entering multiple functions within one setting, pause briefly
between each control pad command. If a command pad is
pressed several times repeatedly, the pad may briefly stop
working. Wait a few seconds, and the pad should function again
as normal.
When power is first supplied to the appliance, everything on the
displays will light up for 5 seconds. Then, "PF" will appear. Press
CANCEL OFF to clear displays.
IIf "PF" appears at any other time, a power failure has occurred.
Press CANCEL OFF and reset the clock if needed.
Oven Display (on some models)
When the oven is in use, this display shows the oven temperature,
heat source(s) and start time.
During Timed Cooking, this display also shows a vertical bar and
minute time countdown and the stop time (if entered).
If "Err" appears on the display, an invalid pad was pressed.
Press CANCEL OFF and retry your entry.
When the oven is not in use, this display is blank.
Time of Day/Timer Display (on some models)
This display shows the time of day or Timer countdown.
The START pad begins any oven function except the Timer,
Control Lock and Sabbath Mode. If not pressed within 5 seconds
after pressing a pad, "START?" will appear on the oven display as
a reminder. If not pressed within 4 minutes after pressing a pad,
the oven display will return to inactive mode (blank) and the
programmed function will be canceled.
The CANCEL OFF pad stops any oven function except for the
Clock, Timer and Control Lock.
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
1. Press CLOCK SET/START.
2. Press number pads to set time of day.
On some models, press the HR and MIN "up" or "down"
arrow pads (buttons) until the correct time shows on the
display.
3. Press START.
11