KitchenAid KERC507 Use & Care Manual page 23

Hide thumbs Also See for KERC507:
Table of Contents

Advertisement

Available languages

Available languages

To Delay Start Self-Clean:
Before delay starting Self-Clean, make sure the clock is set to the
correct time of day. See "Clock" section. Also, make sure the door
is closed completely or it will not lock and the cycle will not begin.
1. Press CLEAN.
Press the number pads to set a clean time other than 3 hours
30 minutes. The clean time can be set between 2 hours 30
minutes and 4 hours 30 minutes.
On some models, press the HR and MIN "up" or "down"
arrow pads (buttons) to set clean time.
2. Press STOP TIME.
On some models, press DELAY START.
3. Press the number pads to enter the time of day to stop.
On some models, press the HR and MIN "up" or "down"
arrow pads (buttons) until the correct time shows on the
display.
4. Press START.
The start time is automatically calculated and displayed. The
door will automatically lock and "DOOR LOCKED" or
"LOCKED" and "DELAY" and the stop time will also appear on
the display (on some models). The door will not unlock until
the oven cools.
5.
When the start time is reached, the oven will automatically
turn on.
When the cycle is complete and the oven cools, "End" will
appear on the oven display and "DOOR LOCKED" or
"LOCKED" will disappear from the display.
Press CANCEL OFF to clear the oven display.
To Stop Self-Clean
any time:
Press CANCEL OFE If the oven temperature
is too high, the door
will remain locked. It will not unlock until the oven cools.
On some models, if the oven temperature is too high after self-
cleaning, then "cln," "TIMED," "ON," "cool" and "LOCKED" will
appear on the display until the oven completely cools.
IMPORTANT: Before cleaning, make sure all controls are off and
the oven and cooktop are cool. Always follow label instructions on
cleaning products.
Soap, water and a soft cloth or sponge are suggested first unless
otherwise noted.
EXTERIOR PORCELAIN ENAMEL SURFACES
(on some models)
Food spills containing acids, such as vinegar and tomato, should
be cleaned as soon as the entire appliance is cool. These spills
may affect the finish.
Glass cleaner, mild liquid cleaner or nonabrasive scrubbing
pad:
Gently clean around the model and serial number plate
because scrubbing may remove numbers.
STAINLESS STEEL (on some models)
Do not use soap-filled scouring pads, abrasive cleaners, Cooktop
Polishing Creme, steel-wool pads, gritty washcloths or some
paper towels. Damage may occur.
Rub in direction of grain to avoid damaging.
Stainless Steel Cleaner & Polish (not included):
See "Assistance or Service" section to order.
Liquid detergent or all-purpose cleaner:
Rinse with clean water and dry with soft, lint-free cloth.
Vinegar for hard water spots
CERAMIC GLASS (on some models)
Do not use steel wool, abrasive powder cleansers, chlorine
bleach, rust remover or ammonia because damage may occur.
Always wipe with a clean, wet cloth or sponge and dry thoroughly
to prevent streaking and staining.
Cooktop Polishing Creme is recommended for regular use to help
prevent scratches, pitting and abrasions, and to condition the
cooktop. It may be ordered as an accessory. See "Assistance or
Service" to order.
A Cooktop Scraper is also recommended
for stubborn soils, and
can be ordered as an accessory. See "Assistance
or Service" to
order. The Cooktop Scraper uses razor blades. Store razor
blades out of the reach of children.
Light to moderate
soil
Paper towels or clean damp sponge:
Clean while the cooktop is still warm. You may want to wear
oven mitts while doing so.
Sugary spills (jellies, candy, syrup)
Cooktop Scraper:
Clean while the cooktop is still warm. You may want to wear
oven mitts while doing so.
Cooktop Polishing Creme and clean damp paper towel:
Clean as soon as cooktop has cooled down. Rub creme into
surface with a damp paper towel or soft cloth. Continue
rubbing until white film disappears.
Heavy soil, dark streaks, specks and discoloration
Cooktop Polishing Creme or nonabrasive cleanser:
Rub product into soil with a damp paper towel or soft cloth.
Continue rubbing until white film disappears.
Burned-on soil
Cooktop Polishing Creme and Cooktop Scraper:
Rub creme into soil with damp paper towel. Hold scraper as
flat as possible on surface and scrape. Repeat for stubborn
spots. Polish entire cooktop with creme and paper towel.
23

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ykers507Ykerc507Kerc508Ykerc508

Table of Contents