Tones - KitchenAid KERC507 Use & Care Manual

Hide thumbs Also See for KERC507:
Table of Contents

Advertisement

Available languages

Available languages

Tones are audible signals, indicating the following:
One tone
Valid pad press
Oven is preheated
Function has been entered
Three tones
Invalid pad press
Four tones
End of cycle
Reminder, repeating each minute after the end-of-cycle
tones
All tones
Press and hold STOP TIME
Reminder
Tones Only
The Minute Timer and Timed Cooking reminder tones are preset
on, but can be turned off.
To Turn Tones Off/On: Press and hold TIMER SET/START until a
tone sounds. Repeat to turn back on.
End-of-Cycle
and Reminder
Tones
The Timer and Timed Cooking end-of-cycle
and reminder tones
are preset on, but can be turned off. However, on double oven
models, if all tones have been turned off, the end-of-cycle
and
reminder tones cannot be independently turned on.
To Turn Tones Off/On: Press and hold COOK TIME until a tone
sounds and the oven display returns to inactive mode (blank).
Repeat to turn back on.
Tone Volume
The volume is preset at high, but can be changed to low.
To Change: Press and hold the number pad 7 for five seconds. A
tone will sound and "Snd Lo" will appear on the oven display for 3
seconds. Repeat to change back to "Snd HI."
To set oven to cook in Celsius instead of Fahrenheit, open oven
door, then press and hold BROIL for 5 seconds. Repeat to change
back into Fahrenheit.
The Timer can be set in minutes and seconds or hours and
minutes and counts down the set time.
NOTE: The Timer does not start or stop the oven.
To Set:
1. Press TIMER SET/START.
Press again to switch between MIN/SEC and HR/MIN.
If no action is taken after 4 minutes, the display will return to
the time of day mode.
2. Press the number pads to set length of time.
On some models, press the HR and MIN "up" or "down"
arrow pads (buttons) until the correct time shows on the
display.
Press TIMER SET/START.
If not pressed within 4 minutes, the display will return to the
time of day mode and the programmed
function will be
canceled.
When the set time ends, if on, end-of-cycle
tones will sound,
then reminder tones will sound every minute.
Press TIMER CANCEL anytime to cancel the Timer and/or
stop reminder tones.
Remember, if CANCEL OFF is pressed, the oven will turn off.
The time can be reset during the countdown by repeating the
above steps.
The Control Lock shuts down the control panel pads to prevent
unintended use of the oven. The Control Lock is preset unlocked,
but can be locked.
When the control is locked, only the TIMER SET/START and
TIMER CANCEL pads will function.
To Lock/Unlock
Control: Before locking, make sure the oven, the
Timer and Timed Cooking are off. Press and hold the number pad
3 CONTROL LOCK for about 5 seconds until "CONTROL LOCK"
and a picture of a lock appear on the display. Repeat to unlock
and remove "CONTROL LOCK" from the display.
IMPORTANT: Do not use a thermometer to measure oven
temperature because opening the oven door during cycling may
give incorrect readings.
The oven provides accurate temperatures;
however, it may cook
faster or slower than your previous oven, so the temperature
calibration can be adjusted. It can be changed in Fahrenheit or
Celsius.
A minus sign means the oven will be cooler by the displayed
amount. No sign means the oven will be warmer by the displayed
amount. Use the following chart as a guide.
ADJUSTMENT
°F
COOKS FOOD
(AUTOMATIC °C CHANGE)
5 ° to 10°F (3° to 6°C)
...a little more
15 ° to 20°F (9 ° to 12°C)
...moderately
more
25 ° to 35°F (15 ° to 21 °C)
...much more
-5 ° to -10°F (-3 ° to -6°C)
...a little less
-15 ° to -20°F (-9 ° to -12°C)
...moderately
less
-25 ° to -35°F (-15 ° to -21 °C)
...much less
To Adjust Oven Temperature
Calibration:
1. Press and hold BAKE for 5 seconds or until the oven display
shows the current calibration, for example, "0° CAL COOK
TEMP" or "0 ° CAL."
2. Press BAKE to increase and BROIL/MAXl/ECONO
to
decrease the temperature in 5°F (3°C) amounts. The
adjustment can be set between 35°F (21 °C) and
-35°F (-21°C).
On some models, press the TEMPERATURE "up" or "down"
arrow pads (buttons) to increase or decrease the temperature
in 10°F (6°C) amounts. The adjustment can be set between
30°F (18°C) and -30°F (-18°C).
3. Press START.
12

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ykers507Ykerc507Kerc508Ykerc508

Table of Contents