Snmp Configuration Commands - Extreme Networks Summit1 Installation And User Manual

A T S
CCESSING HE WITCH
Table 3-7 describes SNMP configuration commands.
Table 3-7: SNMP Configuration Commands
Command
enable snmp access
enable snmp trap
config snmp add <ipaddress> {<mask>}
config snmp add trapreceiver <ipaddress>
community <string>
config snmp add community [read | readwrite]
<string>
config snmp delete [<ipaddress> {<mask>} | all]
config snmp delete trapreceiver [<ip_address>
community <string> | all]
config snmp delete community [read | readwrite]
<string>
config snmp syscontact <string>
config snmp sysname <string>
config snmp syslocation <string>
3-20
Description
Turns on SNMP support for the switch.
Turns on SNMP trap support.
Adds the IP address of an SNMP
management station to the access list. Up
to 32 addresses can be specified.
Adds the IP address of a specified trap
receiver. The IP address can be a
unicast, multicast, or broadcast. A
maximum of 6 trap receivers is allowed.
Adds an SNMP read and write community
string. Each community string can have a
maximum of 127 characters.
Deletes the IP address of a specified
SNMP management station or all SNMP
management stations. If you delete all
addresses, any machine can have SNMP
management access to the switch.
Deletes the IP address of a specified trap
receiver or all authorized trap receivers.
Deletes an SNMP community string.
Configures the name of the system
contact. A maximum of 255 characters is
allowed.
Configures the name of the switch. A
maximum of 255 characters is allowed.
The default sysname is the model name of
the Summit, such as Summit1, Summit2,
Summit3, and so on. The sysname
appears in the Summit prompt.
Configures the location of the switch. A
maximum of 255 characters is allowed.
S
UMMIT
S I U
WITCH NSTALLATION AND SER
G
UIDE