Showing Configuration Details - Extreme Networks Px Series Installation And Configuration Manual

Showing Configuration Details

Table 10-2 lists the commands that are used to display configuration information.
Table 10-2: Configuration Display Commands
Command
show banner
show config
show cookie
show default-gateway
show dns-client
show gatewaymode [config] Displays the current gateway mode.
show gslb [config]
show healthcheck [config
| down | summary |
details | verbose]
show iparp
show iproute
show natmode config
show proxy-ip
show snmp
show sticky [config]
show switch
show system-ip
show timeout
show vlan
show vrrp [details |
autosync | config]
Px Series Application Switch Installation and Configuration Guide
Description
Displays the current startup banner message.
Displays the complete configuration to the screen.
Displays the current status of cookie processing. It is
disabled if no cookie processing is configured.
Displays the default gateway IP address for the Gigabit
Ethernet interface.
Displays the domain name service (DNS) default domain and
the DNS server.
Displays the activities of the GlobalPx Content Director
agent.
Displays the current health check configuration.
Displays the current layer 2 ARP table entries.
Displays the layer 3 forwarding database.
Displays the currently configured NAT mode.
Displays the currently configured proxy IP addresses.
Displays the current SNMP configuration.
Displays which stickiness modes have been configured, and
the configured timer values.
Displays the current version of software loaded in primary
and secondary flash, MAC addresses, and other useful
information.
Displays the IP address of the Gigabit Ethernet interface,
along with its netmask.
Displays the TCP/IP timer settings.
Displays if VLAN support is enabled or not.
Displays the current state of VRRP, including who is the
master and what the priorities are of each system.
Showing Configuration Details
10-3