Table of Contents
Advertisement
Logging
The Px series application switch supports two logging facilities, a local log and the
UNIX
facility for remote logging.
syslog
The application switch log tracks all configuration and fault information pertaining to
the device. The switch maintains 1,000 messages in its internal log. To enable the log,
use the command:
enable log
To view the log, use the command:
show log <level>
The
argument is optional. By default, all messages are shown. The values for
<level>
are:
<level>
displays error messages
a
errors
displays fatal messages
b
fatal
displays informational messages
c
info
displays warning messages
d
warning
To change the level of messages that are logged, use the command:
config log display <level>
The
argument is optional. By default, the level is set to
<level>
To clear the log, use the command:
clear log
In addition to maintaining the internal log, the switch supports remote logging by way
of the UNIX
host facility. To enable remote logging, do the following:
syslog
1 Configure the
syslog
2 Enable remote logging using the following command:
enable syslog
3 Configure remote logging using the following command:
config syslog ipaddress <ipaddress>
4-16
host to accept and log messages.
, fatal messages.
b
Px Series Application Switch Installation and Configuration Guide
Advertisement
Table of Contents
