Utilities
The Px series application switch offers utilities for the following operations:
• Checking Basic Connectivity on page 4-15
• Logging on page 4-16
• Configuring a Startup Banner Message on page 4-17
• Starting the GlobalPx Content Director Agent on page 4-17
Showing CPU Load
Use the following command to show the CPU load:
top
This is similar to the UNIX top command. The idle task,
nothing else is going on.
Checking Basic Connectivity
The Px series application switch offers the following commands for checking basic
connectivity:
• The
ping
echo messages to a remote IP device. This command is available for both the user
and administrator privilege level. The command syntax is:
ping [<ipaddress>|<hostname>]
• The
traceroute
and a destination end station. The command syntax is:
traceroute [<ip_address> | <hostname>]
Px Series Application Switch Installation and Configuration Guide
command enables you to send Internet Control Message Protocol (ICMP)
command enables you to trace the routed path between the switch
, shows 99%-100% if
BGTask
Utilities
4-15