Configuring Dns Client Services - Extreme Networks Px Series Installation And Configuration Manual

Table 4-4: SNMP Configuration Settings
Setting Description
Community The community strings allow a simple method of authentication between the
strings application switch and the remote Network Manager. There are two types of
community strings on the application switch.
Read community strings provide read-only access to the application switch.
The default read-only community string is public.
Read-write community strings provide read and write access to the
application switch. The default read-write community string is private.
A total of eight community strings can be configured on the application switch.
The community string for all authorized trap receivers must be configured on
the application switch for the trap receiver to receive.
Syntax:
* SummitPx1:16 # config snmp add community readonly
<string>
* SummitPx1:17 # config snmp add community readwrite
<string>
Authorized An authorized trap receiver can be one or more network management stations
trap receivers on your network. The application switch sends SNMP traps to all trap
receivers. You can have a maximum of 16 trap receivers configured for each
application switch.
Syntax:
* SummitPx1:17 #config snmp add trapreceiver <ipaddress>
Optionally, you can change the IP port to which traps are sent if the server is
running the syslog process on a non-standard port:
* SummitPx1:17 #config snmp add trapreceiver <ipaddress>
community <string> port <number>

Configuring DNS Client Services

The Domain Name Service (DNS) client in ExtremeWare augments the following
commands to allow them to accept either IP addresses or host names:
• telnet
• download [configuration | image]
• upload configuration
• ping
• traceroute
4-10 Px Series Application Switch Installation and Configuration Guide