Front Panel Leds; Power Supply Cords - Extreme Networks 12800 Series Hardware Installation Manual

Installing Power Supply Units

Front Panel LEDs

The front panel of the Extreme Networks 700/1200 W AC PSU provides status LEDs.
the LED behavior on the front panel.
Table 18: Extreme Networks 700/1200 W AC PSU LEDs
PSU Condition
Power supply AC outputs working normally
AC input power present/standby output on
Current limit on 48 VDC output
Predictive failure
No input power to this PSU only
No input power to any PSU
Power supply failure

Power Supply Cords

Extreme Networks 700/1200 W AC PSU(s) come with both 110 V AC and 220 V AC power supply
cords. The 110 V AC power supply cord allows for a maximum DC output power of 700 W. The 220V
AC power supply cord allows for a maximum DC output power of 1200 W.
CAUTION
All power supply cords provided by Extreme Networks are designed for use in North America only. Power supply
cords for use outside of North America are typically provided by a third-party distribution center and must meet the
following requirements:
Power supply cords must be agency certified for country of use.
●
Power supply cords must contain an IEC 320 C13 connector on the end of the PSU.
●
Power supply cords must contain an appropriately rated and approved wall plug applicable to the
●
country of installation.
Power supply cords must be less than 5 m long.
●
Wire size must be a minimum of 16 AWG (1.0 mm
●
WARNING!
Always be sure that the source outlet is properly grounded before plugging the AC power cord into the Extreme
Networks 700/1200 W AC PSU.
84
Power
Predictive Fail
Green
Amber
On Off
Blinking Off
On Off
On Blinking
Off Off
Off Off
Off Off
2
) copper-stranded.
BlackDiamond 12800 Series Switches Hardware Installation Guide
Table 18 describes
Fail
Amber
Off
Off
Blinking
Off
On
Off
On