Extreme Networks 12800 Series Hardware Installation Manual page 98

Installing Power Supply Units
NOTE
On each two vertically adjacent PSUs, attach the power cord bracket with the tightening screw on top and the
lower power cord bracket with the tightening screw underneath, as shown in
Figure 60: Power Cord Brackets on Two Adjacent Power Supplies
2 Connect the AC power cord to the PSU as follows:
a Connect the AC power cord to the AC input on the front of the PSU (see
loosen the middle screw of the power cord bracket to allow installation of the power cord.
b After the power cord is connected, tighten the middle screw of the bracket to secure the power
cord in place (see
Figure 61: Connecting the AC Power Cord
1
3 Connect the opposite end of the AC power cord to the wall outlet.
NOTE
Leave the ESD strap permanently connected to the switch, so that the strap is always available when you need to
handle ESD-sensitive components.
98
Torino AC PSU_09
Figure 61).
2
Figure
Torino AC PSU_08
BlackDiamond 12800 Series Switches Hardware Installation Guide
60.
Figure 61). If needed,