Kenmore 911.36769 Owner's Manual page 12

CONTROL, CLOCK andgITCHEH
Your new control has a series of tones that will
continued
sound at different times. These tones may
sound while .you set the control for an oven
function, or at the end of the oven function It
will also alert you there may be a problem with
the functions Below are the types of tones
and a brief description of each
TONES WHILE SETTING THE
CONTROL
When you press a touch pad you will hear a
beep. This beep will let you know you have
placed enough pressure on the pad to
activate it. (The arrow pads do not beep)
END OF THMED CYCLE TONE
At the end of a timed cooking function, you will
hear 3 short beeps followed by I beep every
6 seconds. This 6 second beep will continue
to sound until the CLEAR/OFF pad is pressed
or you may select the special feature to cancel
this 6 second beep from sounding at the end
of future cycles_
TO CANCEL THE 6 SECOND BEEP
1, Press and hold the BAKE and BROIL
pads, at the same time for 3
seconds, until the display shows "SF"
2. Press the KITCHEN TIMER ON/OFF
pad,, The displaywill show "CON BEEP"
(continous beep)
3. Press the KITCHEN TIMER ON/OFF
pad again, The display will show"BEEP"
(beep canceled).
4. Press the START pad.,
If you would like to return the 6 second beep,
repeat steps above until the display shows
your choice and press start,.
ATTENTION TONE
This tone will sound if you make an error or an
oversight is made while setting an oven
function.
Examples would be:
a. Setting a timed function and not pressing
the start pad.
b, Pressing an additional function pad
without setting a temperature or time first,
Any of these can be quickly identified by
watching the display
PREHEAT TONE
When you set an oven temperature, the oven
automatically starts to heat. When the
temperature inside the oven reaches the
temperature you have set, a tone will sound to
let you know the oven is ready for baking,
If .you set an oven function and the control
beeps while the display is flashing "F" and a
number "F-4" or letter "Fl" there may be a
problem with the control or oven. Simply press
the CLEAR/OFF pad and wait about an hOUrr
Try setting the function again ff the code
repeats, write down the flashing code and call
for service Tell the technician what the
code was flashing.
112