Creatingyourownsoundmode -- Manual Mode - JVC MX-GT90 Instructions Manual

CreatingYourOwnSoundMode
-- Manual Mode
You can change SEA pattern to suit your preference. These
changed setlings can be stored in the MANUAL 1,
MANUAL 2, and MANUAL 3 modes.
• There is a time limit in doing the following sleps, if the
setting is canceled before you finish, start from step 1
again.
On the unit ONLY:
1
Select one of the
preset
sound modes.
• If you want to add the surround elements in your
SEA pattern, select one of the surround modes
(D.CLUB, HALL, or STADIUM) before starling the
procedure below. (See "Selecting the Sound Modes" on
page 10,)
2 Press and hold SET/DISPLAY
until "SEA CONT" appears on
the display.
4
Press SET/DISPLAY again.
5 Turn I_1_ / i,_l to select one
of the MANUAL 1, 2, and 3
modes into which you want
to store the SEA pattern.
6
Press SET/DISPLAY again.
The SEA pattern you have created are stored into the
MANUAL mode selected in the abo_e step,
_ ¢l_ i_a _'_'_,_,_
_Z_X_ _ _
_._:: I_ I_I I,,I -r -_
/
Current level appears.
Adjust the SEA pattern.
1) Turn I_1_1 / _1 to select
the tYequency range to
adjust (LOW, MID,
HIGH).
2) Press _1_ or _ to
adjust the level (-3 to +3) of
the selected frequency
range.
3) Repeat steps 1) and 2) to
adjust the level of the other
frequency ranges.
+(
Touse yourown sound mode
Select MANUAL 1, MANUAL 2, or MANUAL 3 mode
when using the sound modes. See "Selecting the Sound
Modes" on page 10,
When you unplug the AC power cord or if a power
failure occurs
The setting will be erased in a few days. If this happens, set the
manual sound modes again.
-11 -