Reinforcing The Bass Sound; Activating The Surround Effect; Selecting The Sound Modes; Creating Your Own Sound Mode - Manual Mode - JVC CA-WMD90R Instructions Manual

Reinforcing the Bass Sound

The richness and fullness of the bass sound is maintained
regardless of how low you set the volume.
You can use this effect only for playback.
To get the effect, press ACTIVE BASS EX. (extension) so
that the ACTIVE BASS EX. lamp lights up on the unit.
(in the main display)
To cancel the effect, press the button again so that the
lamp goes off. "OFF" also appears in the main display.

Activating the Surround Effect

You can obtain a "being-there" feeling while listening to
any source.
You can use this effect only for playback.
To get the effect, press SURROUND so that the
SURROUND lamp lights up on the unit.
• Each time you press the button, the surround effect
changes as follows:
NORMAL
(Canceled)
The surround effect increases as you select —:
NORMAL = WIDE = SUPER WIDE
To cancel the effect, press the button repeatedly until the
SURROUND lamp goes off. "OFF" also appears in the
main display.

Selecting the Sound Modes

You can select one of the 5 preset sound modes.
You can use the sound mode only for playback.
To select the sound modes, press SOUND repeatedly so
that the SOUND lamp lights up on the unit.
• Each time you press the button, the sound modes change
as follows:
ROCK VOCAL
FLAT MANUAL=SET?
(Canceled)
ROCK: Good for rock'n'roll.
VOCAL: Good for vocal music.
CLASSIC: Good for classical music.
POP: Enhances middle frequency.
BGM: Good for easy-listening.
MANUAL = = = = = SET?: Your individual mode stored in
memory. See "Creating Your Own Sound
Mode — MANUAL Mode."
FLAT: Cancels the sound mode.
WIDE SUPER WIDE
OFF
CLASSIC
BGM
Creating Your Own Sound Mode —
MANUAL Mode
You can create and store your own sound mode only by
using the buttons and controls on the unit.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
On the unit ONLY:
1
Press SOUND repeatedly until "MANUAL=SET?"
appears in the main display.
2
Press SET.
3
Adjust the equalizer pattern.
1) Rotate the left jog dial to select the frequency
range to adjust (LOW, MIDDLE, HIGH).
2) Rotate the right jog dial to adjust the level (–3 to
+3) of the selected frequency range.
3) Repeat steps 1) and 2) to adjust the level of the
other frequency ranges.
4
Press SET again (or wait until the above indication
disappears).
POP
The equalizer pattern you have created is stored in
memory.
To use your own sound mode
Select "MANUAL =
See "Selecting the Sound Modes."
– 12 –
Adjustable frequency range
= = SET?" when using the sound modes. = =