Usingthe Timers; Usingdaily Timer - JVC MX-GT90 Instructions Manual

Usingthe Timers
There are three timers available Daily Timer, Recording
Timer, and Sleep Timer,
Before using the timers, you need to set the clock built in the
unit, (See page 9.)
UsingDaily Timer
With Daily Timer, you can wake to your favorite music or
radio program. You can set the timer whether the unit is on or
of£
HowDaily Timer actuallyworks
The unit aulomatically turns on, set the volume level to the
preset level, and starts playing the specified source when the
on-time comes (the _ indicator ffashes just before the on-
time, and continues flashing while the timer is operating),
Then, when the off-time comes ("OFF" ffashes just before the
off-time), the unit automatically turns off (on standby),
The Daily timer works everyday automatically.
if you do not want to use the Daily timer, turn offthe Daily
timer, (See "To turn on or offDaily Timer after its selting is
done" on page 22,)
The timer setting remains in memory until you change it,
• There is a time limit in doing the following sleps, if the
setting is canceled before you finish, start from step 1
again.
• To correct a mis-entry while selting the timer, press
CANCEL/DEMO,
Before you start...
• When using the tuner as the source toplay
Make sure to select a desired station.
• When using a CD as the source to play
Make sure there is a CD on the selected disc number
tray.
• When using a tape as the source to play
Make sure that a tape is in the deck whose deck
indicator (A or B) is lit on the display,
Make sure that the tape direction is correct,
• When using the external component as the source to
pl.y
Set the timer equipped on the external component at
the same time.
On the unit ONLY:
1 Press CLOCK/TIMER repeatedly
until "DAILY" appears on the
display.
_) indicator lights up and DAILY (Daily
Timer) indicator also starts flashing on the
display,
3t- ; L ','
• Each time you press the button, the timer selting modes
change as follows:
_Bi ON TIME"_'RECq
c,ock--O.
setting
(See page 9)
Press CLOCK/TIMER again.
"ON TIME" appears for 2 seconds, then the
unit enters on-time setting mode,
\-
3
Set the on-time you want the unit to turn on
at.
1) Turn 1,9141 / _ to set the hour,
then press SET/DISPLAY.
2) Turn 1,4141 / _ to set the minute,
then press SET/DISPLAY.
"OFF TIME" appears for 2
seconds on the display, then the
unit enlers off:time setting mode,
4
Set the oil:time you want the
unit to turn off
(on standby)
at.
1) Turn I..*1_ / _ to set the hour, then press
SET/DISPLAY,
2) Turn I..(14/ _ to set the minute, then press
SET/DISPLAY,
The unit enlers source selecting mode.
_Z_E_Iq.Ay
-21 -