Connecling Other Equipment; Cancelingthe Displaydemonstration - JVC MX-GT90 Instructions Manual

1 Open the speaker terminals on the rear of the
unit.
2 Insert the end of the speaker cord into the
terminal.
Malch the polarity (colors) of the speaker lerminals: Red
(+) io red (+) and black @) to black ( ); Blue (+) to blue
(+) and black ( ) to black (),
3 Close the speaker terminals.
IMPORTANT: Use only speakers with the same speaker
I
impedance as indicated by the speaker terminals on the
I
rear of the unit.
Connecting OtherEquipment
You can connect both analog and digital equipment,
._- DO NOT connect any equipment while the power
I
is on.
I
• DO NOT plug in any equipment until all
connections are complete.
Toconnectan analogcomponent
Be sure that the plugs of the audio cords are colored: White
plugs andjacks are for left audio signals, and red ones for
right audio signals,
Toconnectaudio equipmentwith an optical digital
inputterminal
You can record CD sound onto the connecled digital
equipment.
Before connecting the
other equipment,
remove the protective
plug from the terminal.
[
I Audio equipment with
' _
I an optical digital input
To optical digital input _
Connect an optical digital cord (not supplied) between the
optical digital input terminal on the other equipment and the
CD OPTICAL DIGITAL OUTPUT lerminal.
To audio output
Audio equipment
For playing the other equipment through this unit,
connect between the audio output jacks on the other
equipment and AUX jacks by using audio cords (not
supplied).
Now, you can plug the AC power cord.
When connecting the AC power cord into a wall outlet, the
unit automatically starts display demonstration,
IMPORTANT: Be sure to check all connections to be done
before plugging the AC power cord into a wall outlet.
Cancelingthe displaydemonstration
On the unit ONLY:
To cancel the display demonstration, press
CANCEL/DEMO until "DEMO OFF" appears
on the display.
_When you press other buttons
The display demonstration stops tempormily. It will start
automatically again (if no operation is done for 2 minutes) until you
cancel it by pressing CANCEL/DEMO.
To start the display demonstration manually
Press and hold CANCEL/DEMO again for more than 1
second.
-8-