Battery Charger; 3.10 Storage Procedure; Lubricating System; Fuel System - Kohler 12RES Operation And Installation Instructions Manual

3.9 Battery Charger
The generator set is equipped with a 6-amp
float/equalize battery charger to maintain the engine
starting battery. The charger's DC leads are
factory-wired. Figure3-11 illustrates the battery
charger.
1
2
3_
5
zJ
1. LED indicators
2. Mounting flanges
3. Battery leads, 12 VDC
4. Fuse
5, AC powerco_
Figure 3-11 6-Amp Float/Equalize Battery Charger
Periodically tighten all connections. No other
maintenance on the battery charger is required.
3.10 Storage Procedure
Perform the following storage procedure before
removing the generator set from service for three
months or longer. Follow the engine manufacturer's
recommendations for storage, if available.
Note: Run the generator set monthly whenever
possible.
3.10.1 Lubricating System
1. Operate the generator set until it reaches operating
temperature, or about 15 minutes.
2. Stop the generator set.
3. While the engine is still warm, drain the engine
lubrication oil from the engine crankcase.
4. Refill the engine crankcase with oil. See Section
3.3.3 for oil recommendations.
5. Run the generator set for a few minutes to
distribute the clean oil.
6. Stop the generator set.
3.10.2 Fuel System
1. Start the generator set.
2. With the generator set running, shut off the gas
supply.
3. Run the generator set until the engine stops.
4. Place the generator set master switch in the
OFF/RESET position.
3.10.3 Cylinder Lubrication
1.
2.
Remove the spark plugs.
Pour one tablespoon of engine oil into each spark
plug hole. Install the spark plugs and ground the
spark plug leads. Do not connect the leads to the
plugs.
3. Toggle the generator set master switch to crank the
engine two or three revolutions to lubricate the
cylinders.
3.10.4 Exterior Preparation
1. Clean the exterior surface of the generator set.
2. Seal all openings in the engine with nonabsorbent
adhesive tape.
3. Mask all areas to be used for electrical contact.
4. Spread a light film of oil over unpainted metallic
surfaces to prevent rust and corrosion.
TP-6195 1/04 Section 3 Scheduled Maintenance 17