,_
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
WARNING:
To avoid injury to hands
and feet, always disengage clutches,
shut off engine, and wait for all
movement to stop before unclogging
or working on snow thrower.
Keep hands and feet away from auger
and impeller.
CONTROLS AND FEATURES
See Figure 1 for all Controls and Features
locations.
Traction
Drive
Clutch
- Left Hand
Bail
2
/ ....
!
0L2702
Ignition
Switch
i
Key Switch has two positions:
1. "Stop"- pulled out
2. "Run"- pushed in
NOTE:
DO NOT twist key
after it is inserted.
1
Primer
Bulb
--
Pushing the primer bulb in adds
fuel for easier engine start.
Refer to Starting and Shut Off.
Speed
Selector
The Speed Selector controls the unit travel in a
forward or reverse direction when positioned
in notch of speed.
Squeeze the Traction Drive Clutch Bail against
the Handlebar (1) to engage wheel drive for
propelling unit. Forward speed will vary
according to snow depth and moisture
content.
Release bail (2) to stop movement.
NOTE: When traveling to or from the area to
be cleared, press down on the handlebars
enough to raise the front of the unit slightly off
the surface. Engage the traction drive clutch
Forward:
without engaging the attachment
drive clutch.
Attachment
Clutch
- Right
Hand
Bail
m
b/-q
1 C
OLI692
Squeeze Attachment
Clutch Bail against
handlebar (1) to engage attachment.
Release
both clutch bails (2) to disengage
power and
apply brake to attachment.
IMPORTANT:
If the belt squeals when the
attachment
clutch bail is engaged, the
attachment
drive may be frozen. Immediately
release the attachment
clutch bail and move
the unit into a heated area to thaw.
W
W
6
5
4321
_
1
2
mm
(6) Fastest
(1) Slow
©$2400
Reverse:
_
1) Slow
!_
(2) Fast
IMPORTANT:
DO NOT change motion from
forward to reverse with clutch engaged.
Forward speed can be changed without
declutching.
GB - 14