Using The Rp01 For Controlling The Rtm Parameter (Rtm Mode) - Zoom Player 3000B Operation Manual

Using the RP01 for Controlling the RTM Parameter (RTM Mode)

This section describes how to use the RP01 for controlling RTM or Volume RTM.
1
Verify that the RP01 is properly connected to the 3000B.
STEP
2
STEP Set the FUNCTION switch (FUNCTION Mode parameter) to one of modes 1 - 8.
For details, please refer to page 21.
If the FUNCTION Mode is set to "9: RTM", the control pedal of the
NOTE
RP01 will only function as master volume pedal.
FUNCTION switch (3000B) and control pedal (RP01) operation (RP01 in RTM mode)
FUNCTION Mode
parameter setting
When FUNCTION Mode
= 1 - 8
When FUNCTION Mode = 9
3
Call up a patch for which RTM/Volume RTM has been set.
STEP
For information on making settings for the RTM function, please refer to
page 21. When a patch has been called up, the RP01 is always in RTM
mode and the RTM MODE LED is lit.
4
Operate the control pedal of the RP01 while playing your
STEP
The parameter adjusted with the control pedal depends on the effect
type selected for the patch and on the RTM/Volume RTM setting. It is
also possible to control several parameters at a time.
ADVANCED BASS EFFECTS PROCESSOR
PEDAL SW
STATUS
MONITOR
PEDAL-WAH ON/OFF(PEDAL SW)
PEDAL-PITCH ON/OFF(PEDAL SW)
VOLUME ASSIGN
MODE DELECT
RTM MODE
MODE SELECT DELAY MODE (PEDAL SW TRIGGER)
FUNCTION switch
(3000B) operation
Function selected with
FUNCTION Mode parameter
RTM/Volume RTM control
5, 6
5, 6
4
Control pedal (RP01)
operation
RTM/Volume RTM control
Master volume control
35