Zoom Player 3000B Operation Manual page 48

Parameter 2 Spd
Determines the time delay until the effect sets in.
Parameter 3 Color
Determines the sound character.
Parameter 4 Mode
Two methods can be selected for detecting the pitch
to be used as reference for producing the effect
sound. Use the method that yields a more stable
effect pitch.
Parameter 5 Level
Parameter 6 WAH RTM
Sets the maximum (minimum) value for the RTM
control parameter denoted by the
When set to "oF", RTM control is disabled for that
module.
When using this effect, play only single notes. If a
NOTE
chord is played, the pitch cannot be detected
correctly.
Type 4 PHASE
This effect adds a phase-shifted component to the
signal. By varying the amount of phase shift, a wave
effect is achieved.
Parameter 1 Dpt
Determines the depth of the phaser effect.
Parameter 2 Spd (
Sets the speed of the phase shift variation.
Parameter 3 Color (Resonance)
Determines the depth of the resonance that adds a
special character to the phaser effect.
Parameter 4 Mode (Stage)
Varies the phaser sound in eight distinct stages,
allowing you to fine-tune the effect.
Parameter 5 Level
Parameter 6 WAH RTM
Type 5 ENH (Enhancer)
Emphasizes a certain frequency range, making the
sound more distinct and prominent. Two enhancer
effects can be used simultaneously.
Parameter 1 F1
Determines the frequency range to be emphasized by
the first enhancer.
Parameter 2 G1 ( RTM)
Determines the intensity of the first enhancer.
Parameter 3 F2
Determines the frequency range to be emphasized by
the second enhancer.
Parameter 4 G2
Determines the intensity of the second enhancer.
44
( RTM)
mark.
RTM)
Parameter 5 Level
Parameter 6 WAH RTM
Type 6 P-EQ (Parametric Equalizer)
This is a parametric equalizer that allows boost/cut in
two separate frequency ranges.
Parameter 1 F1
Determines the boost/cut frequency range for the
first equalizer.
Parameter 2 G1
Determines the boost/cut amount for the first
equalizer.
Parameter 3 F2
Determines the boost/cut frequency range for the
second equalizer.
Parameter 4 G2
Determines the boost/cut amount for the second
equalizer.
Parameter 5 Level (
Parameter 6 WAH RTM
Type 7 GRAPHIC EQ
(Graphic Equalizer)
This is a 4-band graphic equalizer which mainly
provides boost/cut in the lower frequency range.
Parameter 1 500Hz
Determines the boost/cut amount in the 500 Hz
range.
Parameter 2 250Hz
Determines the boost/cut amount in the 250 Hz
range.
Parameter 3 100Hz
Determines the boost/cut amount in the 100 Hz
range.
Parameter 4 50Hz
Determines the boost/cut amount in the 50 Hz range.
Parameter 5 Level (
Parameter 6 WAH RTM
ADVANCED BASS EFFECTS PROCESSOR
RTM)
RTM)