Table of Contents
Advertisement
Depending on the selected effect type, the content of
parameter 1 changes.
Type 1 CLN1 (Clean 1)
Clean sound with flat frequency response.
Convenient when wishing to use only the amp
simulator.
Type 2 CLN2 (Clean 2)
Clean sound making optimum use of the
characteristic bass sound.
Type 3 TE-C (TE-Clean)
Clean sound emulating a high-quality bass amplifier.
Type 4 SW-C (SW-Clean)
Clean sound emulating a wide-range bass amplifier.
Parameter 1 Mid Enh (
Higher values result in more prominent midrange.
This parameter is the same for Type 1 - 4.
Type 5 OD (Overdrive)
Effect with solid overdrive sound.
Type 6 FUZZ
Effect with strongly distorted fuzz sound.
Type 7 FN-D (FN-Drive)
Vintage tube-amp type overdrive distortion.
Type 8 AC-D (AC-Drive)
Overdrive sound such as produced by a bass
amplifier with a pronounced midrange.
Parameter 1 Gain (
RTM)
Determines the amount of distortion.
This parameter is the same for Type 5 - 8.
Common parameters for Type 1 - 8
Parameter 2 Level
Determines the level of the effect sound.
Parameter 3 D. Level
Determines the level of the original sound.
Parameter 4 Cabinet
This amp simulator effect adds a cabinet sound to the
original bass sound.
42
RTM)
oF:
The amp simulator effect is off.
C0 - C9: Simulates a combo type speaker cabinet.
The numeral adjusts the depth of the
effect.
S0 - S9: Simulates a stack type speaker cabinet.
The numeral adjusts the depth of the
effect.
Parameter 5 DIST-WAH/WAH-DIST
This parameter determines the connection sequence
of the DIST/AMP module and the WAH module
(page 43).
1: DIST-WAH: The WAH effect module comes
after the DIST/AMP effect module.
DIST/AMP
2: WAH-DIST: The WAH effect module comes
before the DIST/AMP effect
module.
WAH
Parameter 6 DIST/AMP RTM
Sets the maximum (minimum) value for the RTM
control parameter denoted by the
When set to "oF", RTM control is disabled for that
module.
ADVANCED BASS EFFECTS PROCESSOR
WAH
DIST/AMP
(
RTM)
mark.
Advertisement
Table of Contents
