Troubleshooting - Zoom Player 3000B Operation Manual

Troubleshooting

If there seems to be a problem with the unit, please check the following points first.
Problem
• Is the AC adapter connected correctly
and the power ON?
• Is the INPUT jack correctly connected to the
guitar, and the OUTPUT jack to the amplifier?
• Is your shielded cable ok?
• Is the connected amplifier's power ON?
• Are volume settings of instrument and
amplifier appropriate?
No Sound, or
Extremely Small
• Is input sensitivity (INPUT ATT) set
Sound
extremely low?
• Is the LEVEL parameter setting for each
effect module appropriate?
• Is the 3000 muted?
• Master volume turned down?
• Volume turned down with RP01 (option)
foot pedal?
• Is the 3000B in Manual mode?
Patches Do
Not Switch
• Is the 3000B in Store standby status or
All Initialize standby status?
• Is a patch with RTM selected?
• Was an effect type which allows Pedal Wah
RTM (including
or Pedal Pitch Shifter selected?
Pedal Wah and
Pedal Pitch
• Is Effect Monitor LED off (flashing)?
Shifter) and
Volume RTM
cannot be
• Is RP01 set to DELAY mode?
operated with
foot pedal of
RP01.
• Is FUNCTION switch of 3000B set to
"9: RTM"?
Pedal wah or
pedal pitch
• Is RP01 set to DELAY mode?
shifter does not
turn on or off
when
integrated
• Was an effect type which allows Pedal
switch of RP01
Wah or Pedal Pitch Shifter selected?
pedal is
pressed.
54
Check Remedy
Turn the power ON by following the
instructions, "GETTING CONNECTED".
Connect them correctly by following the
instructions , "GETTING CONNECTED".
Try changing your shielded cable.
Turn the amplifier's power ON.
Adjust the volume to the appropriate level.
Set input sensitivity to a suitable level (see
page 13).
Enter the Edit mode (see page 15) and
appropriately adjust the levels for each
parameter.
If the FUNCTION switch mode (see page 22)
is set to "MUTE", press the FUNCTION
switch to turn off the mute condition.
Turn VALUE knob in Play mode to adjust
the volume (see page 8) .
Operate RP01 foot pedal.
Press FUNCTION switch to return to Play
mode.
Press the STORE key to execute the
operation, or press the EDIT key to leave the
standby status and return to Play mode.
Activate Edit mode and make the RTM
settings (page 27).
Verify that PEDAL (WAH module) or P-PIT
(EFFECT module) is selected as effect type
(see page 43, 49).
Press pedal switch so that LED becomes on
(lit).
Press Mode Selector of RP01 to switch to
RTM mode.
When FUNCTION switch mode is set to "9:
RTM", the control pedal of the RP01
functions as volume pedal. Select another
mode (see page21–22).
Press Mode Selector of RP01 to switch to
RTM mode.
Verify that PEDAL (WAH module) or P-
PIT (EFFECT module) is selected as effect
type (see page 43, 49).
ADVANCED BASS EFFECTS PROCESSOR