Using The Rp01 For Controlling The Rtm; Target Parameter (Rtm Mode) - Zoom player 3000 Operation Manual

Using the RP01 for Controlling the RTM Target Parameter (RTM Mode)
This section describes how to use the RP01 for controlling the RTM parameter set for the patch.
1
Verify that the RP01 is properly connected to the 3000.
STEP
Before connecting the RP01, make sure that the 3000 is turned off.
NOTE
Connecting the pedal while the 3000 is on can lead to malfunction.
2
Set the FUNCTION switch to one of modes 1 - 5.
STEP
For details, please refer to the section "Using the FUNCTION switch"
on page 18.
If the FUNCTION switch is set to mode 6 or 7, the function of the
NOTE
RP01 will be different. Please refer to page 34.
3
Call up a patch for which RTM has been set.
STEP
For information on making settings for the RTM function, please refer to
page 23.
NOTE
Whenever a new patch is called up, the RP01 will be in RTM mode.
4
Operate the Control pedal of the RP01 while playing your instrument.
STEP
As opposed to using the FUNCTION switch on the 3000, the
Control pedal allows continuous variation of the RTM control
target parameter in both directions, and the value can also be
fixed to a desired point.
RTM parameter is positive
Value of
effect parameter
set by RTM
Reference value
RP01
ADVANCED GUITAR EFFECTS PROCESSOR
RTM MODE
DELAY MODE
RTM LED of RP01 lights up
RTM parameter is negative
Reference value
Value of
effect parameter
set by RTM
RP01
MODE SELECT
(PEDAL SW TRIGGER)
33