Zoom player 3000 Operation Manual page 41

EQ
This effect module comprises a 3-band equalizer, phaser, and wah effects.
Parameter 1
1. 3-BAND EQ
TYPE
Parameter 2
Parameter 3
Parameter 4
Parameter 5
Parameter 6
Parameter 7
Parameter 1 TYPE (Effect Type)
The following four effect types can be selected for
the EQ effect module.
Type 1 3-BAND EQ
Type 2 PHASE (Phaser)
Type 3 PEDAL-WAH
Type 4 AUTO-WAH
Depending on the selected effect type, the content of
parameters 2 - 7 changes.
Type 1 3-BAND EQ
This 3-band equalizer allows adjusting the high-
frequency range, mid-frequency range, and low-
frequency range.
Parameter 2 High
Controls boost/cut for the high-frequency range.
Parameter 3 Midf
The midrange frequency can be selected from the
following values: 0.2 (250 Hz), 0.4 (400 Hz), 0.8
(800 Hz), 1.2 (1.25 kHz), 2.0 (2 kHz), 3.1 (3.15
kHz), 5.6 (5.6 kHz), 8.0 (8 kHz).
Parameter 4 MidG
Determines boost/cut for the mid-frequency range.
Parameter 5 Low
Controls boost/cut for the low-frequency range.
Parameter 6 Level ( RTM))
Determines the module output level.
A setting of "25" yields flat response.
Parameter 7 EQ RTM
Determines the change direction and control range
for the parameter marked with " RTM".
ADVANCED GUITAR EFFECTS PROCESSOR
2. PHASE 3. PEDAL-WAH
Type 2 PHASE (Phaser)
Adds a phase-shifted effect component to the direct
sound, creating a special undulating sound.
Parameter 2 Depth
Determines the depth of the phaser effect.
Parameter 3 Rate ( RTM)
Determines the speed of the phaser effect.
Parameter 4 Reso
Determines the resonance component of the phaser
effect.
Parameter 5 Stage
Determines the number of stages for the phaser
effect. When set to "8", a detailed phaser effect is
achieved.
Parameter 6 Level
Parameter 7 EQ RTM
Type 3 PEDAL-WAH
This effect type allows use of the optional remote
pedal RP01 or the FUNCTION switch of the 3000
for pedal wah.
Parameter 2 High
Controls boost/cut for the high-frequency range.
Parameter 3 f
Determines the initial frequency (when pedal is not
operated).
Parameter 5 Low
Controls boost/cut for the low-frequency range.
Parameter 6 Level
Parameter 7 EQ RTM
Determines the direction in which the wah effect
changes when the pedal is pressed. "dn" means a
downward change and "UP" an upward change.
4. AUTO-WAH
39