Receiver Led Indicators - Salus ST320RF Instruction Manual

ST320RF Manual Version 005:Layout 1

RECEIVER LED INDICATORS

The LED indicators on the ST320RF Receiver are designed to give a clear and easily understood
indication of the current state of the system.
The various LED signal combinations and descriptions of what they indicate are shown in the table
below:
LED State
Blue Flashing
once per
second
Blue Off
Blue On (Not Flash)
Green On
Green Flashing
for 4
seconds
Red On and
flashing
Yellow On
ST320RF INSTRUCTION MANUAL
21/10/10
Indication
Receiver is in Automatic mode and system is calling for heat.
Receiver is in Automatic mode and system is NOT calling for heat
Receiver is in Manual mode and system is calling for heat
Power is on
Receiver has received correct RF address and Command
signal when in Failsafe mode
Receiver is either ready to receive a new RF address code in SYNC mode,
or has failed to store the new RF address code when in SYNC mode
Receiver is in Failsafe mode after no RF signal received for over 1 hour
15:32 Page 13
13