On The Receiver - Salus ST320RF Instruction Manual

ST320RF Manual Version 005:Layout 1 21/10/10 15:32 Page 8
PAIRING THE ST320RF RECEIVER AND CONTROL CENTRE
It is important to correctly pair both the Receiver and Control Centre to ensure that the RF address codes
are matched and that reliable communication is established between the units. Please follow the
instructions below to ensure that the units are configured correctly.

ON THE RECEIVER:

Press and hold the SYNC button to allow the Receiver to enter the learning mode. The Red SYNC LED will
turn on to indicate it is ready to receive a signal and pair with another unit.
While the signal is being received, the SYNC LED will turn on until the pairing has completed successfully;
the SYNC LED will then turn off and the Green Power LED will turn on again. The Control Centre will
continue to transmit a pairing signal for 10 minutes before returning to NORMAL mode.
8 ST320RF INSTRUCTION MANUAL