Changing The Set Temperature - Salus ST320RF Instruction Manual

ST320RF Manual Version 005:Layout 1 21/10/10 15:32 Page 19
If the ST320RF is operating in Frost Mode the LCD will display both the room
temperature and also the Frost Mode indicator . To turn off FROST mode, select
the FROST menu and then by using the Touch Ring scroll to the OFF setting. OFF
will then be displayed on the LCD.
After pressing the Touch Ring, the LCD will display the preset Frost Mode
temperature of 5 ºC (this temperature is factory set and cannot be adjusted).
Pressing the OK or Arrow keys will return the ST320RF to NORMAL mode.

CHANGING THE SET TEMPERATURE

When the ST320RF is in NORMAL mode, press the Touch Ring anywhere
except the OK and Arrow keys (as described in the previous section), to enter
the Review Set Temperature mode. The currently set temperature will be
displayed on the LCD and will flash.
When the set temperature is flashing, press the Touch Ring and move your
finger clockwise to increase the set temperature, or anti-clockwise to
decrease the set temperature. Press OK at any time to confirm the selection.
Note that the set temperature display will not flash while being adjusted – this is normal and the display
will start to flash again approximately 0.5 seconds after the Touch Ring is released.
The ST320RF will go back to NORMAL mode without changing the set temperature after 10 seconds of
inactivity, or after pressing the Arrow key.
If the ST320RF is in FROST mode, the set temperature cannot be adjusted. Turn off FROST mode
as described below to allow the set temperature to be changed.
ST320RF INSTRUCTION MANUAL 19