System Connections; Volume Control; Speaker Connection; Using Other Subwoofer - Sharp XL-HF200P (BK Operation Manual

System connections

Make sure to unplug the AC power lead before making any connections.
FM aerial
Wall socket (AC 120 V ~ 60 Hz)
Precautions
Please ensure that the equipment is positioned in a well ventilated area
and ensure that there is at least 4" (10 cm) of free space along the sides,
top and back of the equipment.
4" (10 cm)
4" (10 cm)
Use the unit on a fi rm, level surface free from vibration.
Place the speakers at least 12" (30 cm) away from any CRT TV to avoid
colour variations across the TV screen. If the variations persist, move
the speakers further away from the TV. LCD TV is not prone to such
variation.
Keep the unit away from direct sunlight, strong magnetic fi elds, excessive
dust, humidity and electronic/electrical equipment (home computers,
facsimiles, etc.) which generate electrical noise.
Do not place anything on top of the unit.
Do not expose the unit to moisture, to temperatures higher than 140˚F
(60˚C) or to extremely low temperatures.
If your system does not work properly, disconnect the AC power lead
from the Wall socket. Plug the AC power lead back in, and then turn on
your system.
In case of an electrical storm, unplug the unit for safety.
Hold the AC power plug by the head when removing it from the Wall
socket, as pulling the lead can damage internal wires.
The AC power plug is used as a disconnect device and shall always
remain readily operable.
Do not remove the outer cover, as this may result in electric shock.
Refer internal service to your local SHARP service facility.
This unit should only be used within the range of 41˚F - 95˚F (5˚C -
35˚C).
Warning:
The voltage used must be the same as that specifi ed on this unit. Using
this product with a higher voltage other than that which is specifi ed is
dangerous and may result in a fi re or other type of accident causing
damage. SHARP will not be held responsible for any damage resulting
from use of this unit with a voltage other than that which is specifi ed.
To prevent fi re or shock hazard, do not expose this appliance to dripping
or splashing. No object fi lled with liquids, such as vases shall be placed
on the apparatus.
AM loop
aerial
Right
speaker
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
4" (10 cm)
4" (10 cm)
Installing the AM loop aerial
< Attaching
to the wall >
< Assembling >
wall
screws (not supplied)

Volume control

The sound level at a given volume setting depends on speaker effi ciency,
location, and various other factors. It is advisable to avoid exposure to high
volume levels. Do not turn the volume on to full at switch on. Listen to music at
moderate levels. Excessive sound pressure from earphones and headphones
can cause hearing loss.

Speaker connection

Connect the black wire to the minus (–) terminal,
and the red wire to the plus (+) terminal.
Use speakers with an impedance of 4 ohms or
more, as lower impedance speakers can damage
the unit.
Do not make a mistake when connecting the right
and left speakers. The right speaker is the one on
the right side when you face the unit.
Do not let the bare speaker wires touch each other.
Do not allow any objects to fall into or to be placed in the bass refl ex
ducts.
Do not stand or sit on the speakers. You may be injured.

Using other subwoofer

You can connect a subwoofer with an amplifi er to the SUBWOOFER PRE
OUT socket.
Audio cable
(commercially
Audio signal
available)
To audio
input socket
To SUBWOOFER
PRE OUT socket
Main unit
Notes:
No sound is heard from the subwoofer without a built-in amplifi er.
Subwoofer Pre-out (audio signal): 200mV / 10k ohms at 70 Hz.
E-2
Video cable
(not supplied)
To video input socket
Left
speaker
Red
Black
Commercially available subwoofer
(amplifi er built in)
Incorrect