General Control; Remote Control; Display Brightness Control; Battery Installation - Sharp XL-HF200P (BK Operation Manual

System connections (continued)
Connecting a TV, etc.
Connect to the TV using an audio cable.
TV
Main unit
To select Line In function:
On main unit: Press FUNCTION button repeatedly until Line In is
displayed.
On remote control: Press AUDIO/LINE (INPUT) button repeatedly until
Line In is displayed.

Remote control

Battery installation

Use 2 "AAA" size batteries (UM/SUM-4, R3, HP-16 or similar).
Batteries are not included.
Plastic fi lm covering can be removed or peeled off.
1
Open the battery cover.
2
Insert the batteries according to the direction indicated in the battery
compartment.
When inserting or removing the batteries, push them towards the
battery terminals.
3
Close the battery cover.
Caution:
Replace all old batteries with new ones at the same time. Do not mix old
and new batteries.
Do not mix old and new batteries.
Remove the batteries if the unit will not be used for a long period of time.
This will prevent potential damage due to battery leakage.
Do not use rechargeable batteries (nickel-cadmium battery, etc.).
Installing the batteries incorrectly may cause the unit to malfunction.
Batteries (battery pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, fi re or the like.
Notes concerning use:
Replace the batteries if the operating distance is reduced or if the
operation becomes erratic. Purchase 2 "AAA" size batteries (UM/SUM-4,
R3, HP-16 or similar).
Periodically clean the transmitter on the remote control and the sensor
on the unit with a soft cloth.
Exposing the sensor on the unit to strong light may interfere with
To audio
operation. Change the lighting or the direction of the unit.
output socket
Keep the remote control away from moisture, heat, shock, and
vibrations.
Audio cable

General control

(commercially
available)
The fi rst time the unit is plugged in, the unit will enter the demonstration mode.
Power on/ off
Demo on/ off
To LINE IN
input socket
To dim the display brightness, press the DEMO/DIMMER button on the
remote control.
If you turn off and on the main unit with the volume set to 27 or higher, the
volume starts at 16 and fades in to the last set level.
Turn the volume knob towards VOL +/- (on main unit) or press VOLUME
+/- (on remote control) to increase or decrease the volume.
When you press any of the following buttons, the unit turns on.
The main unit will enter the stand-by mode (when iPod/iPhone is not docked)
after 15 minutes of inactivity during:
iPod/iPhone: No connection.
AUDIO IN / LINE IN: No detection of input signal or very low sound audibility.
TUNER: No reception of broadcast signal.
CD / USB: In the stop mode.
Note:
However, if iPod/iPhone is docked, the unit will begin charging.
"Charge Mode" will be displayed.
E-3
To turn the power on
Function Main unit
____

Display brightness control

Dimmer 1 (Display is dim).
(Display gets dimmer).
Dimmer 2
(Display is bright).
Dimmer off
Volume illuminator
When the power is turned on, volume illuminator lights up.
To turn on/off the light, hold down the DEMO/DIMMER button on the
remote control for more than 2 seconds.
Volume auto fade-in
Volume control
Auto power on function
®
iPod / iPhone, CD, USB, AUDIO / LINE (INPUT), TUNER (BAND) on the
remote control: Selected function is activated.
button on the main unit: The unit turns on and playback of the last
function will start (CD, TUNER, USB, iPod, AUDIO IN, LINE IN)
Auto power off function
Remote
Operation
control
Press to turn the
power on or to go to
stand-by mode.
Press to enter to
demonstration on or
off mode.