Enhancing Your System; Troubleshooting Chart - Sharp XL-HF200P (BK Operation Manual

Enhancing your system

The connection lead is not included. Purchase a
commercially available lead as shown below.
Audio cable (not supplied)
Listening to the playback sounds of
portable audio player, etc.
1
Use a connection lead to connect the portable audio
player etc. to the AUDIO IN socket. When using video
equipment, connect the audio output to this unit and
the video output to a television.
2
Press the ON/STAND-BY button to turn the power on.
3
Press the AUDIO/LINE (INPUT) button on the remote
control or FUNCTION button repeatedly on main unit
to select AUDIO IN function.
4
Play the connected equipment. If volume level of the
connected device is too high, sound distortion may
occur. Should this happen, lower the volume of the
connected device. If volume level is too low, increase
the volume of the connected device.
Note:
To prevent noise interference, place the unit away from the
television.
Headphones
Do not turn the volume on to full at switch on and listen
to music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing
loss.
Before plugging in or unplugging the headphone,
reduce the volume.
Be sure your headphone has a 3.5 mm diameter
plug and impedance between 16 and 50 ohms. The
recommended impedance is 32 ohms.
Plugging in the headphone disconnects the speakers
automatically. Adjust the volume using the VOLUME
control.
Portable audio
player, etc.

Troubleshooting chart

Many potential problems can be resolved by the owner
without calling a service technician.
If something is wrong with this product, check the following
before calling your authorised SHARP dealer or service
centre.
General
Symptom
The clock is not
set to the correct
time.
When a button is
pressed, the unit
does not respond.
No sound is heard.
CD player
Symptom
Playback does
not start.
Playback stops
in the middle or
is not performed
properly.
Playback sounds
are skipped, or
stopped in the
middle of a track.
Remote control
Symptom
The remote
control does not
operate.
Tuner
Symptom
The radio makes
unusual noises
continuously.
E-12
Possible cause
Did a power failure occur?
Reset the clock.
(Refer page 10)
Set the unit to the power
stand-by mode and then turn
it back on.
If the unit still malfunctions,
reset it. (Refer page 13)
Is the volume level set to "Min"?
Are the headphones connected?
Are the speaker wires disconnected?
Possible cause
Is the disc loaded upside
down?
Does the disc satisfy the
standards?
Is the disc distorted or
scratched?
Is the unit located near
excessive vibrations?
Is the disc very dirty?
Has condensation formed
inside the unit?
Possible cause
Is the AC power lead of the
unit plugged in?
Is the battery polarity
correct?
Are the batteries dead?
Is the distance or angle
incorrect?
Does the remote control
sensor receive strong light?
Possible cause
Is the unit placed near the
TV or computer?
Is the FM aerial or AM loop
aerial placed properly? Move
the aerial away from the AC
power lead if it is located
nearby.