Autopage C3-RS1100 OLED Installation Manual page 27

CHECK LEVEL PROGRAMMING: (TEST and ADJUST)
1. Press button once on the transmitter to start the vehicle.
2. If everything goes well:
a. Press button once on the transmitter to stop engine running. You have been
completed this programming successfully.
b. Press button on the transmitter to exit the program mode. There will be 3 long
chirps & 3 parking light flashes for confirmation.
3. If the crank time is too long, (Engine already successfully running, but still cranks):
a. Press once on the transmitter to stop engine running or press brake pedal.
Press button on the transmitter to set prope r "Check Level " to Low position.
[1] LED flash, [1 chirp will confirm this setting
b. Repeat steps 1 – 4 if necessary.
4. If the crank time is too short, (Engine not running, crank stopped before starting):
a. Press button once on the transmitter to stop engine running.
Press button on the transmitter to set proper " Check Level " to Hi position. [2]
LED flash, [2 chirps will confirm this setting
Repeat steps 1 – 4 if necessary.
VOLTAGE CHECKING TYPE
1. Turn the Ignition 'switch ' ON/OFF' 3 TIMES and stay in OFF position.
2. Push the Valet switch 11 times and hold it on the 11
long chirp is hearing then release the valet switch.
3. Press the transmitter
Checking Type". [2] LED flashes , [2] chirps to confirm this setting
Once you complete step 3, you can adjust and test "Start Timer" as below:
START CRANK TIME PROGRAMMING: (TEST and ADJUST)
1. Press button once on the transmitter to start the vehicle.
2. If everything goes well:
Wait for 15 seconds:
a. If the engine still running.
I. Press button once on the transmitter to stop engine running. You have
been completed this programming successfully.
II. Press button on the transmitter to exit the program mode. There will be 3
long chirps & 3 parking light flashes for confirmation.
b. If the engine shuts down after the vehicle has been started.
I. Press button once on the transmitter to stop engine running.
II. Press button on the transmitter to set "Check Level" to LOW position. [1]
LED flash, [1] chirp to confirm this setting
III. Repeat steps 1 – 2.
3. If the crank time is too long, (Engine already successfully running, but still cranks):
a. Press button once on the transmitter to stop engine running.
b. Press button on the transmitter to set proper "Start Timer". The chirp & LED
pause will confirm entry. (Decrease "Start Timer" is necessary.)
c. Repeat steps 1 – 4 if necessary.
4. If the crank time is too short, (Engine not started, crank time stopped):
a. Press button once on the transmitter to stop engine running.
C3 RS1100REV. A
th
push until five chirps with a
and buttons at the same time to set the "Voltage
27