Autopage C3-RS1100 OLED Installation Manual page 26

"TEST" Mode for
Zone 2 / instant
+
6
tri gger & Zone 3 /
Door trigger
+ 50 RPM
7 +
DBI ONLY
- 50 RPM
8 +
DBI ONLY
Automatic
9 +
Transmission
Exit: Press the button on the transmitter. 3 long chirps & 3 parking light flashes will
confirm exit.
** This will be used when connected to an Autopage CI3 compatible
Two-way data module that will recognize the tach signal from the vehicle.
This signal will need to be learned in the same manner as the analog
tachometer wire. If this learned value needs to be adjusted, use steps 7
and 8 of this programming table
IMPORTANT NOTE:
You must program the "Tach Signal" before trying to remote
start.
RPM LEARNING / TACHOMETER CHECKING TYPE
1. Turn the Ignition switch 'ON/OFF' 3 TIMES and stay in OFF position.
2. Push the Valet switch 11 times and hold it on the 11
long chirp is hearing then release the valet switch.
3. Press and release the transmitter
the "Tachometer Checking Type". [1] LED flash, [1] chirp to confirm this setting.
4. Press and release the transmitter
indicate your are in features "RPM Learning mode".
5. Start the vehicle with the key. (While the engine is running, the parking & LED will
flash, If don't, please check tachometer White/Red wire connection. (H10/15)
6. Press and hold the valet switch for 2 seconds until a long chirp and the LED light
constant for two seconds. The RPM signal is learned.
7. Turns off the ignition switch to stop the engine running.
Once you complete step 7, you can adjust and test "Check Level" as below:
C3 RS1100REV. A
"TEST" Mode for
Zone 1 & Zone 4
(2 Stage Shock
Sensor)
No RPM learning
No RPM
Learning or <
50RPM
th
push until five chirps with a
and buttons at the same time once to set
button once, [1] LED flash, [1] chirp to
26