Alarm Feature “A” Programming - Autopage RF-350 Installation & User Manual

Note: If more than 4 transmitters are programmed, the system will only
keep the last 4 transmitters and delete the others.
ALARM FEATURE "A" PROGRAMMING:
1. Turn the Ignition 'switch 'ON/OFF' 3 TIMES and stay in OFF position.
2. Push the Valet switch 3 times and hold in on the 3
chirp is heard, release the valet switch. You are now in the Alarm
feature 'I' programming mode.
3. Press the transmitter button corresponding to the feature you want to
program.
a. The factory default settings is always [1] LED flash, [1] chirp.
4. Depress the transmitter button again to change the feature. Simply
keep pressing the transmitter button again until the module advances
to your desired setting.
Exit: Turn Ignition to 'ON' position, or leave it for 15 seconds. 3 long
chirps will confirm exit.
One Chirp /
Press
LED one pulse
Transmitter
Factory Default
Button
Setting
1
Active arming
2
Automatic Rearm off
Instant Door Ajar error
3
chirp
Siren Confirmation
4
chirp on only
5 +
H2/2 White wire=
Dome Light Output
Lock/Arm &
6 +
Unlock/Disarm
Confirmation Chirps
ALARM with
7.
+
Keyless Entry
8. +
Car Jacking feature
Off
rd
push. When a long
Three Chirps
Two Chirps / /
LED two pulses LED three
pulses
Passive
Passive arming
arming with
without passive
passive door
door locking
locking.
Automatic Rearm
on
45 seconds delay
Door Ajar error
chirp.
Horn
All Confirmation
Confirmation
chirps On
chirp on only
H2/2 White =
H2/2 White wire=
rd
3 Channel
rd
3 channel
Momentary
Latched
Lock/Arm
Confirmation
Chirp Only
Keyless Entry
ONLY
Car Jacking
feature On
6
Four Chirps /
LED four
pulses
All
Confirmation
chirps off