Table of Contents
Advertisement
SVMASTER -
X. Clear the Flash Icon and Melody Sound:
next time the Ignition is cycled to the ON position.
Y. Stop The Trigger Melody Sound:
through a melody sound and a flashing trigger icon. Press any button on the LCD remote transmitter to stop
melody sound only.
Z. Vibration / Melody Mode:
Press and hold the
scroll through the menu. Scroll to the word "
press the trunk button once to enter programming . Press the
Vibrate). Once a setting is chosen. Press the
A. TO REMOTE START THE VEHICLE:
When you want to start your vehicle,
1. Press
button once on the transmitter.
2. The parking light will activate to indicate the remote start received the signal.
3. The engine will start in approximately 5 seconds.
4. Once the engine is running, after couple seconds the parking lights will turn on and the climate controls
will activate and adjust the vehicle's interior temperature to your preset setting. (While the vehicle is running,
the "minutes" digit on the LCD screen will flash and the will indicate countdown timer based on the 5, 10,
20 or 30 minute run time set up by your installation center.)
5. The vehicle will run for a programmable 5 to 30 minute cycle before shutting down. (When the unit
shuts off the countdown timer will turn off and the transmitter will play a melody.)
NOTE: The Remote Start Unit will not start the vehicle if any one of the following conditions exists:
1. The hood is opened.
2. The brake pedal is pressed.
3. The optional remote start enable toggle is switched to the "OFF" position. (If installed)
4. The gear selector is in any gear other then "PARK" or "NEUTRAL".
SAFE START (Child safety mode)
Factory default is set to press the
feature to eliminate an accidental remote start:
1. The user presses the transmitter
2. The user presses the transmitter
NOTE: Contact your installing dealer to activate this feature.
B. OPERATE THE VEHICLE WHILE RUNNING FROM THE REMOTE START:
To operate the vehicle while the engine is running from the remote start,
1. Insert the ignition key and turn it to "ON" (not the start) position.
2. Press the brake pedal.
Note: If the brake pedal is pressed before the key is in the ON position, the engine will shut down.
C. TEMPORARY STOP FEATURE:
This feature allows the vehicle to remain running after the key has bee n removed from the ignition. This
feature is useful for occasions when you wish to exit and lock the vehicle for short periods of time, but would
like to leave the motor running and the climate control on.
SVMASTER -
While triggering the alarm the LCD screen will alert the user
(see advanced users menu for more info)
F
button until 2 beeps are heard. You will see the word
REMOTE START OPERATION:
button once on the transmitter to start the vehicle. You can program this
buttons twice within 3 seconds to start the vehicle. or
and
buttons at the same ti me to start the vehicle.
http://www.msvmaster.lv
-
The Transmitter will reset the flashing icons the
Vibrate". When you see the word "Buzzer Vibrate",
button to change the setting. (Buzzer, BZ VIB,
button to confirm.
http://www.msvmaster.lv
-
10
.Press the trunk button
to
Hide quick links:
Advertisement
Table of Contents
