Programming; Programming Transmitters:; Starter Disable ( Optional ) - Autopage RF-350 Installation & User Manual

2 STEP DOOR UNLOCK WIRE CONNECTION FOR
POSITIVE SWITCHED DOOR LOCKS
+12V
8-Pin
H2/8
Plug
Gray Wire
From
Alarm
H3/3 Green Wire
Door Lock
H3/1 Blue
Wire
Door Unlock
OEM Driver's
Door Lock
Motor

STARTER DISABLE ( Optional )

<12V (+) Ignition>
<Starter Wire (key side)>
<Starter Wire (motor side)>
STARTER

PROGRAMMING TRANSMITTERS:

Enter:
1. Turn the Ignition 'switch 'OFF/ON' 3 TIMES and stay in ON position.
Within 15 seconds,
2. Push the Valet switch 2 times and hold in on the 2nd push. When a
long chirp is heard release the valet switch. You are now in the
Transmitter programming mode.
Program:
1. Press any button on the first transmitter until the siren responds with
a confirming chirp. The first transmitter is now programmed.
2. Press any button on the second transmitter until the siren responds
with a confirming chirp. The second transmitter is now programmed.
3. Apply the same procedure to program any 3rd or 4
Exit: Turn Ignition to the 'OFF' position, or leave it for 15 seconds. 3 long
chirps will confirm exit.
OEM Door Master Lock Switch
8 7
Unlock
86 87A 85
Existing Pos.
3 0
Unlock Wire + 12V
Existing Pos.
Lock Wire
87
87A
+ 12V
85
86
3 0
+ 12V
OEM Door
Lock Relay
87
87A
85
86
3 0
X
Cut Existing Unlock
RK-1
87
<Red>
87a
85 86
<Yellow>
30
<Purple>

PROGRAMMING

5
Lock
To All Other
Door Lock
Motors
Orange
<White Wire>
Starter Disable
Wire
th
transmitter.