Changing The Battery In Your Transmitters - Autopage RF-350 Installation & User Manual

CHANGING THE BATTERY IN YOUR TRANSMITTERS

XT-33:
The XT-33 transmitter uses two (2) 3-volt lithium ion batteries (#CR2016) that
are sandwiched together with the (+) side facing upward. To replace the battery, you will
need to use a small flat blade screwdriver. Locate the small notch on the lower right side of
the transmitter case next to the key ring. Using the flat blade screwdriver, carefully pry the
top case from the bottom case. It should snap apart after breaking the seal. Before
removing the batteries note the direction of the positive (+) terminal. Place the new
batteries in exactly the same manner, being careful not to bend or damage the contac t
terminal. Snap the cases back together and then test the transmitter to insure it arms and
disarms the alarm.
(2) CR2016
3-Volt Batteries
Additional remotes can be purchased at:
www.autopageusa.com
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions.
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
13