Squaring Blade To Table For Ripping - Craftsman 113.197250 Operator's Manual

Squaring Blade to Table for
Ripping
1. Unlock the swivel lock and turn the motor
to the out-rip position with the motor between
the blade and fence. (Figure 87)
Fig. 87- Out-tip Position
2. Lock swivel lock and rip lock.
3. Place the long edge of the framing square
on the table and the short edge against the
blade alongside the arbor shaft. Make sure the
square is against the surface of the blade and
not on the set of a tooth. (Figure 88)
4. Turn the blade with your hand several
times and check to see if the square is flush
with the blade.
5. If the square is flush with the blade after
each rotation (Figure 89) go to step 11, or
If there is a gap between the square and the
blade after any rotation (Figure 89), go to
step 6.
1
[---
Table Fence
Wrong Wrong
Tael
Fig. 89
6. Loosen the hex nut on the rear carriage
bearing. Use a 9/16 inch wrench to hold the
bolt and a 1/2 inch wrench to loosen the nut.
(Figure 90)
Fig. 90
Fig. 88
34