Attaching The Leg Set; Mounting The Saw To Cabinet - Craftsman 113.197250 Operator's Manual

Mounting the Saw to Cabinet
1. Hold the saw by the front edge and the
back of the column support, and lift it onto
the cabinet. It may be necessary to have
someone help you lift the saw. Make sure that
four holes in the bottom of the saw line up
with four holes in the top of the cabinet.
2. Fasten the saw to the cabinet with four
truss head bolts. Put a lockwasher and hex nut
on each bolt and tighten using a 7/16 inch
wrench or socket.
0_igure 31)
Fig. 32 - Support Bracket, LevelingFoot
Leg
_ Support Bracket
Fig. 33
Truss Head Bolt
saw II
Cabine__jj
kockwasher-_
Hex Nut
,-1o,
[ Cabinet [
?(Top View)_
,%
2. Put a hex nut on each of the levering feet.
Put the levering feet through the holes in the
bottom of the J7oor leveler support bracket.
3. Put another hex nut on each of the leverng
feet and hand-tighten until they are against the
leg.
Fig. 31
3. Check all the nuts holding the cabinet
together and tighten them using a 7/16 inch
wrench or socket.
Attaching the Leg Set
MODEL 113.197250
1. Mount floor leveler support brackets inside
legs. Line up the three tabs on brackets with
slot on leg and tap into place. Make sure lip
on bracket points up. (Figure 33)
Install the remaining three brackets the same
way.
Leg
Support Bracket
Fig. 34
Nuts
_Leveling Foot
17