Assembly; Attaching Leveling Feet; Assembling Leg Set - Craftsman 113.248340 Owner's Manual

Assembly ......
Attaching Leveling Feet
1_ From the loose parts find the following items:
Item Description Qty.
A Levelingfeet ........................................................ 4
B Hex nut 3/8-16 .................................................... 8
From the loose parts find the following items:
C Leg...................................................................... 4
2. Put a hex nut on each of the leveling feet and screw it
down towards the rubber foot.
3, Put the leveling feet through the holes in the bottom of
each leg.
4. Put another hex nut on each of the leveling feet and
hand tighten until they are next to the bottom support
of the leg.
WARNING: After the band saw has been attached
to the legset, it will be necessary to adjust the lev-
eling feet so the saw does not rock.
C
B
Assembling Leg Set
1. From the loose parts bag find the following hardware:
Item Description Qty.
A M8 x 1.25-16 carriage bolts .............................. 40
B M8 washers ...................................................... 40
C M8 Iockwashers ................................................ 40
D M8 nuts ............................................................. 40
From the loose parts find the following items:
E Legs (with attached leveling feet) ....................... 4
F Stiffeners (short) ................................................. 2
G Stiffeners (long) .................................................. 2
H Stand top ............................................................ 1
G
A B
F
2. Place stand top upside down on a level surface. Fasten
four legs to top using carriage bolts, washers, lock
washers, and nuts, as shown. Note: Legs fasten to
outside of top. Do not tighten at this time.
3. Fasten two long stiffeners and two short stiffeners to
stand legs using carriage bolts, washers, Iockwashers.
and nuts, as shown. Finger tighten only at this time.
A
B C D
G
F
10
H