Yoke Assembly - Craftsman 113.251890 Owner's Manual

l!. YOKE ASSEMBLY
Step two will require the following parts:
ITEM DESCRJPT|ON QTY,
A 5" Pulleys ............................. 2
B Pulley Shaft Collars ................... 2
C Socket Head Setscrews, I/4-20 x t/4" .. 2
D Pulley Shaft ........................... 1
E Yoke Sub-Assembly ................... 1
F Counterweight Shaft ................... 1
G Pan Head Screws, 10-32 x 3/4" . ........ 2
H Stylus Mount .......................... 1
J Large Knob ........................... 1
K Small Knob ........................... !
L Socket Head Setscrew, 5/16-18 x t/4" .. 1
D
Place the Counterweight Shaft inside the rear of the
Yoke with the bent section of the Shaft extending
out and upward. The two holes in the Shaft should
align with the two small holes in the Yoke as shown.
Secure it with the two 3/4 inch pan head screws,
COUNTER WEIGHT
SHAFT
YOKE ASSEMBLY
YOKE
BEARING
/
ROUTER MOUNT
STYLUS MOUNT
Screw the large and small Knobs and a 1/4 inch
setscrew into the Stylus Mount as shown.
Slide this assembly on to the Router Mount Shaft as
shown and lightly tighten the setscrew.
STYLUS
MOUNT
SETSCREW