Craftsman 113.251890 Owner's Manual page 6

CHECK FOR SQUARENESS OF
: CORNERS BEFORE TIGHTENING
When assembling the above pieces do not tighten
the screws until you have checked all four cornerS of
the assembly with your square.
\
Instafl a third Shelf Board horizontally us_ngthe last
two holes in the:top of each Track Bracket,
The Shelf Brackets should be on the underside of
the Shelf and sus pended from the Track Brackets by
four 1-1/4 inch Pan head screws and four Hex nuts
as shown.
Before tightening the screws check the distance
from the edge of the horizontal She{f Board to the
front Shelf Board as shown. The distance shouEd be
equal when measured at both the left and rig ht side
of the frame assembly,
You should have one shelf board, two she If brac kets
and their related hardware remaining. Thisshelf will
be installed later, after you determine what type of
work will be done.
6 ¸