Planning - Craftsman 139.53962SRT1 Owner's Manual

Planning (continued)
ONE-PIECE DOOR INSTALLATIONS
* Generally, a one-piece door does not require
reinforcement. If your door is lightweight, refer to
the information relating to sectional doors in
Installation Step 11.
Depending on your door's construction, you may
need additional mounting hardware for the door
bracket (Step 11).
Without a properly working safety reversal system,
persons (particularly small children) could be
SERIOUSLYINJUREDor KILLED by a closing garage
door.
• The gap betweenthe bottom of the garage door and
the floor MUST NOTexceed 1/4". Otherwise, the safety
reversal system may not work properly.
• The floor or the garage door MUST be repaired to
eliminate the gap.
ONE-PIECE DOOR WITHOUT TRACK
FINISHED CEILING
Support bracket
& fastening
hardware is required.
See page 17.
Header Wall
Rai_
Motor unit
Safety Reversing Sensor
J
Access
Door
Safety Reversing
Gap between floor Sensor
and bottom of door must not exceed 1/4"
Wall-mounted
Door Control
eader
/all
I
_o
dead
I__ , , , Reversing I
__st be level Sensor _ [
/ SafetY-- _v across width of door I
Revers ng Sensor |
I
CLOSED POSITION
Trolley Stop Bolt Cable
I
Bracket Rait
Door Bracket
Curved
Door
Arm
e Door
Trolley
Emergency
Release
Rope & Handle
CLOSED POSITION
Trolley Stop Bolt Cable
Header Curved "_T_-'_
Bracket aoorArm_ / L_
ooooooooooo) j
"_- Door
y///_ Bracket Straight
Door
_/_, Garage Arm
///4 Door
Chain
Rait
Emergency
Release
Rope &
Handte