Set Rs232 Parameters - Oki OKIPOS X400 Manual

Command Structure <ESC>CRaaaaa,b,c,d
Command Function To select the desired RS232 communication settings.
Input to Printer
Printer Output
Special Notes
1.
2.

Set RS232 Parameters

aaaaa = Baud rate (9600, 19200 or 38400)
b = Parity (N for None, O for Odd, E for Even)
c = Number of data bits (7 or 8)
d = Number of stop bits (1 or 2)
Example: <ESC>CR9600,N,8,1
Placement: Must be sent in a separate data stream.
Default: 9600,N,8,1
<ESC>A
<ESC>CR9600,N,8,1
<ESC>Z
There is no printer output as a result of this command.
Any commands sent to the printer over the RS232 port within two
seconds of receiving the command may be lost.
The RS232 settings must match those of the host system. If the RS232
settings are unknown, printing a Self Test label will list the current
settings.
94