Forms Tear-Off Set To On - Oki Microline 421N User Manual

Setting Top of Form (TOF):

Forms Tear-Off Set to ON

Important!
If you turn the platen knob when the printer is on, the Top of
Form misaligns. Always turn the printer off before turning
the platen knob!
Note: The first line prints at the red line (1) of the plastic
paper shield on the printhead.
With paper loaded and the printer on and selected:
1 Press (6) to park the paper.
PARK
The SEL light goes off and the red alarm light comes on.
2 Press (2) and
SHIFT QUIET/TOF
3 Press (4) to load the paper.
FF/LOAD
4 Wait briefly until the paper moves up to the tear position,
then press and hold
TEAR
The paper moves to the current TOF.
5 Keep holding , then press and hold
TEAR
release .
TEAR
6 Continue to hold
SHIFT
Note: When you begin pressing the Micro Feed key, the
printhead will move to the right.
• Press
LF | Micro Feed Down
paper moves down).
• Press
FF/LOAD | Micro Feed Up
(the paper moves up).
7 When you have the TOF set where you want it, press and
hold (2), then press
SHIFT
setting.
The printhead moves back to the left margin.
8 Press (1) to save the setting and place the printer
SEL/MENU
back on line.
Note: To reset the Top of Form to the factory default, see the
next page.
(7) to reset the current TOF.
(5).
(2) and
SHIFT
, then
(3) to set the TOF higher (the
(4) to set the TOF lower
(7) to engage the new
QUIET/TOF
Using Your Printer
15