Using Fiery Utilities For The First Time; Configuring The Connection For Fiery Utilities - Oki C9800hdn Software Installation Manual

1

1-49 Using Fiery utilities for the first time

Using Fiery utilities for the first time
Before you can use the newly installed software, you must configure the connection to
the Fiery.

Configuring the connection for Fiery utilities

The first time you start one of the Fiery utilities, you must configure the connection to
the Fiery. Similar configuration is used for all Fiery utilities, so a change in one
configuration affects all the other connections. Configuration for most Fiery utilities is
described in the following procedure.
For configuration of specific Fiery utilities, see
Command WorkStation"
B
EFORE YOU BEGIN
• Print the Configuration page from the C9800 Control Panel.
This page contains information you need when configuring the connection, such as
the IP address. For TCP/IP installations, you can use the DNS name of the Fiery
instead of the IP address. Make sure the Fiery is already registered in a Domain Name
Server (DNS) on your network. For more information, see your Windows system
documentation.
T
O CONFIGURE THE CONNECTION FOR
1. Start the utility for which you want to configure a connection.
For details, see the Printing Guide.
2. If the No Servers Configured dialog box appears, click OK.
If the Choose Printer Device dialog box appears, click Add.
3. Enter the appropriate information for the Fiery.
—Enter a name for the Fiery. This name does not have to match the actual
Nickname
Server Name of the Fiery.
The nickname cannot contain any of the following seven characters:
N :
OTE
[ ] _ " ' <space> <tab>
"Configuring the connection for
on page 1-51.
F
IERY UTILITIES