Completing The Windows 2000/Xp/Server 2003 Printer Connection - Oki C9800hdn Software Installation Manual

1
1-31 Setting up PostScript or PCL printing with Windows 2000/XP/Server 2003
3. In the PS driver, to display the C9800's current default settings when opened, select
Update Fiery Driver When Opened.
4. Click Update.
5. In the PS driver, to receive an e-mail notification after your job has been printed,
select Enable E-mail Notification, and type in the e-mail address to which notification
should be sent.
You will also receive e-mail notification of any errors that occur during printing.
Enable E-mail Notification is displayed only if Email Service is enabled at Setup.
N :
OTE
6. Click OK.
Completing the Windows 2000/XP/Server 2003
printer connection
To print from Windows 2000/XP/Server 2003, you must:
• Set up network servers, if any.
• Set up the Fiery to accept print jobs from your computer.
• Configure a port on each Windows 2000/XP/Server 2003 computer for the
network type.
Configure the parallel connection
Configure the TCP/IP (LPR port)
connection
Configure the IPX (Novell) connection
The procedures for completing the printer connection for Windows 2000/XP
N :
OTE
and Windows Server 2003 are similar. Windows 2000 illustrations are used in the
following procedure, with relevant Windows XP differences noted.
To do this See
"Completing the Windows 2000/XP/Server
2003 parallel port connection"
"Completing the Windows 2000/XP/Server
2003 TCP/IP and Port 9100 or
LPR connection" on page 1-33.
"Completing the Windows 2000/XP/Server
2003 IPX (Novell) connection"
in this section.
on page 1-34.