Oki C9800hdn Software Installation Manual page 47

1
1-33 Setting up PostScript or PCL printing with Windows 2000/XP/Server 2003
Completing the Windows 2000/XP/Server 2003 TCP/IP and Port 9100 or
LPR connection
If you installed the driver from the Drivers CD (CD1), this procedure is not
N :
OTE
necessary. TCP/IP connection will have been set up automatically during the
installation.
Once you have installed the PostScript and printer driver files, complete the setup
for the TCP/IP and LPR connection as follows:
• Prepare the Fiery to accept print jobs using TCP/IP and LPR protocols.
For details, see Chapter 2 of the Configuration Guide.
• Install OKI LPR software utility from the Drivers CD (CD1).
• Run OKI LPR and add the printer by discovery on the network. (See the Help
screens with the OKI LPR utility.)
Before you continue, contact the system administrator for the IP address assigned to
the Fiery, as well as the subnet mask and the gateway address, if they are used.
The TCP/IP protocol should already be installed on the Windows 2000/XP/Server
2003 workstation.
You can also set up the LPR connection by installing Print Services for UNIX,
N :
OTE
which is supplied as an add-on Windows component with your Windows
2000/XP/Server 2003 CD. For more information, see your Windows documentation.
T TCP/IP P
O SET UP AND ORT
2000/XP/S 2003
ERVER
1. Insert the Drivers CD (CD1) and wait for the CD Installer to autorun.
If the setup program does not start after a minute or so, navigate to the CD top level
directory and run setup.exe.
2. Choose you preferred installer language and wait for main installer screen to appear.
If necessary, click Accept when prompted to accept the licence conditions.
3. Follow the directions of the main installer screen to install OKI LPR and then the OKI
Network Extension from the available software utilities.
4. When installation if complete, exit the CD Installer program.
9100 LPR
OR CONNECTION FOR
W
INDOWS