Oki C9800hdn Configuration Manual page 150

A
A-2 Troubleshooting
After this Setup screen
Frame Type selection
(Network Setup >Protocol
Setup >IPX/SPX Setup)
Enable NDS
(Network Setup > Service
Setup > PServer Setup > NDS
Setup)
Select NDS Tree
(Network Setup > Service
Setup > PServer Setup >
NDS Setup)
Navigating NDS tree
(Network Setup > Service
Setup > PServer Setup >
NDS Setup)
Bindery Setup
(Network Setup > Service
Setup > PServer Setup >
Bindery Setup)
This message
Invalid frame size.
Warning! IPX network
number is zero.
No NDS trees found.
Warning! Selecting a new
NDS tree deletes Bindery
setup.
___ is empty.
If you also plan to use NDS,
set up NDS before Bindery.
Means
The network hub is not connected to a Novell machine
when the Fiery tries to bind.
No other IPX machine can be found on the network, or
the network hub is not connected to the network when the
Fiery tries to bind. When this occurs, the network number
defaults to zero.
No NDS trees were found on the Novell network. Check
to see that the frame types on the Fiery are
properly configured.
You have previously connected the Fiery to a different
NDS tree. NetWise supports only a single NDS tree con-
nection. To avoid a potential conflict with an existing tree
connection (for example, if the connection was made
through a NetWare 4.x server in emulation mode), all
bindery settings will be deleted.
If you choose OK, and choose Yes in the following message
(Delete Bindery setup and continue?), bindery settings are
deleted and have to be re-entered in Bindery Setup.
To avoid deleting the bindery settings, select OK and
choose No in the following message (Delete Bindery setup
and continue?).
Repeat NDS Setup without changing the NDS tree, or exit
to Bindery Setup to review your current bindery settings.
The chosen container contains no sub-containers or objects
relevant to the current mode of navigation.
No NDS settings are present. You are reminded to perform
NDS Setup before Bindery Setup in case your network
includes both NDS and bindery servers.