Creating file systems with ext2
1.
Enter mkfs
Example
# mkfs
2.
Repeat step 1 for each device on the disk array.
Creating the mount directories
Create mount directories using the mkdir command. Choose names for the mount directories
which identify both the logical volume and partition.
1.
Enter mkdir /mnt/mount_point.
Example
# mkdir /mnt/A5700F_LU00
2.
Repeat step 1 for each device on the disk array.
Creating the mount table
Add the new devices to the /etc/fstab file to specify the automount parameters for each device.
1.
Edit the /etc/fstab file to add one line for each device to be automounted.
Each line of the file contains: (A) device name, (B) mount point, (C) file system type ("ext2"),
(D) mount options ("defaults"), (E) enhance parameter ("1"), and (F) fsck pass 2.
Example
/dev/sdb
/dev/sdc
/dev/sdd
A
Make an entry for each device. After all the entries are made, save the file and exit the editor.
2.
Reboot the system.
t ext2 /dev/device_name.
t ext2 /dev/sdd
/A5700F_ID08
ext2
/A5700F_ID09
ext2
/A5700F_ID10
ext2
B
C
defaults
1
2
defaults
1
2
defaults
1
2
D
E
F
Configuring disk array devices
85