HP XP20000/XP24000 Configuration Manual page 108

Table 24 Device parameters-queue depth (IBM AIX)
Parameter
Queue depth per LU
Queue depth per port (MAXTAGS)
The recommended queue depth settings might not provide the best I/O performance for your
system. You can adjust the queue depth setting to optimize the I/O performance of the disk array.
Displaying the device parameters using the AIX command line
At the command line prompt, enter lsattr -E -l hdiskx, where hdiskx is the device file
name.
Example
# lsattr
Changing the device parameters using the AIX command line
1. To change the R/W timeout parameter, enter:
chdev
2. To change the queue depth parameter, enter:
chdev
where x is a value from the previous table.
3. To change the queue type parameter, enter:
chdev
For example, enter the following command to change the queue depth for the device hdisk3:
# chdev
4. Verify that the parameters for all devices were successfully changed.
For example, enter the following command to verify the parameter change for the device
hdisk3:
# lsattr
5. Repeat these steps for each OPEN-x device on the disk array.
TIP: The lsattr command also shows useful information, such as LUN ID of the mapped
LDEV, worldwide name of the disk array FC port, and N-Port ID.
Another useful command for determining the slot position and port worldwide name of the
FCA is the lscfg
Changing the device parameters using SMIT
1. Start SMIT. (Optional) For an ASCII session, use the smit
2. Select Devices.
Example
System Management
Move cursor to desired item and press Enter.
Software Installation and Maintenance
Software License Management
Devices
System Storage Management (Physical & Logical Storage)
108 IBM AIX
E -l hdisk2
1 hdiskx a rw_timeout='60'
l hdiskx a queue_depth='x'
l hdiskx a q_type='simple'
l hdisk3 a queue_depth='2'
E l hdisk3
l hdiskx command.
v
Recommended Value
32
1024
C command.