[root@cb-xen-srv31 ~]#
Configuring disk array devices
Disks in the disk array are configured using the same procedure for configuring any new disk on
the host. This includes the following procedures:
1.
Configuring multipathing
2.
Creating a Storage Repository
3.
Adding a Virtual Disk to a domU
4.
Adding a dynamic LUN
Configuring multipathing
Follow these steps to configure multipathing using XenCenter.
XenCenter is available with Citrix XenServer Enterprise Edition. To install XenCenter, type the dom0
IP address into a Web browser. In the XenCenter section, click the XenCenter MSI installation file
link to install the application.
NOTE:
Make sure to perform these steps on every server.
1.
Open XenCenter and make sure all of the dom0s are in a pool.
2.
Right-click the dom0 and select Enter Maintenance Mode.
3.
Click Enter Maintenance Mode .
Configuring disk array devices
121